What is the difference between a 1-Plug and 2-Plug unit Brake Control Wiring Harness?

All vehicle specific Brake Control Wiring Harnesses are available in 1-Plug or 2-Plug styles:

1-Plug units are designed for brake controls manufactured with electrical wiring mounted on the back  on the unit. This is also know as the pigtail. Wiring harnesses must be spliced into the existing pigtail to  allow the vehicle specific plug to be installed.

On trailer hitch #65068 can you confirm if the receiver will stick out past the license plate once it is relocated?

As per technical support at Cequent Towing Products, the receiver will stick out past the licence plate. 

1. Measure from the tow hook bolt center to level ground.

2. Subtract 3-5/8”(3.625)[92mm] from step 1. This is the distance from level ground to bottom of fascia cutout.

3. Mark the location of the bottom of fascia cutout on front of fascia.

4. Measure 3-1/4” up from the bottom of fascia cut. This is the location of the top of fascia cutout.

5. Locate the center of the fascia from left to right and mark 1-5/8” each side. ( 3-1/4” square)

6. Drill (4) 3/8” hole in corners.

7. Carefully cut the 3-1/4” hole from the fascia.

Is it common to experience sway on a weight distrubution system with built-in sway?

It is common to experience sway on a weight distribution system with built in sway control under the following circumstances:

1) It is a windy day
2) The tire pressure on your trailer or vehicle is low

If you are still experiencing sway on days with low to no wind, and your tire pressure is at its recommended level, contact the manufacturer's tech team to see what can be done. Unfortunately, on many built-in sway control systems you are unable to adjust the sway control so you may be limited for options, although that may be different with sway control kits like the Dual Cam Sway Controls.

What are Happijac Tiedowns?

as taken from happijac.com

HappiJac’s design combines frame strength and sound engineering principles to create an I-beam truss structure that makes your camper an integral part of the truck, providing unsurpassed strength and security. Its Direct-to-Frame™ mount is strong and easy to use. While other tie downs may "hold your camper down," only HappiJac Tie Downs prevent camper movement in all directions (up-down, side-to-side, and front-to-back).

Happijac Tiedowns are vehicle specific. Click on the link and use the Vehicle Seearch on the left side of the page to find the correct Tiedowns for your vehicle. 

How is the length on a hitch adapter measured?

The hitch adapters can be measured in two different ways:

1) From pin hole to pin hole
2) From the receive tube to the very back of the adapter

Here is an example of how the REESE 2" TO 1-1/4" RECEIVER ADAPTER is measured

Click on the link to view our selection of Receiver Hitch Adapters