PullRite Capture Plates are a required component of the SuperGlide hitch system. When the trailer is hooked up to the hitch, the Capture Plate’s wedge isolates the king pin from turning in the fifth wheel plate, causing the Cam Assembly to activate and allowing the SuperGlide to move as turns are being made. Most applications slip over the king pin and are held in place by a set screw. Follow the instructions below to determine your correct Capture Plate

HOW TO CHOOSE THE CORRECT PULLRITE CAPTURE PLATE:

1) Find the manufacturer’s name and model number located on your pin box

2) Then find the Quick Connect part number that corresponds to that information

3) To ensure correct fit, make the necessary A, B and C measurements:

A: Measure the king pin plate from side-to-side. This is the most important measurement. Be sure that this measurement is no more than 1/16” less than the measurement listed in the column below.

B: Measure from the leading edge of the king pin to the leading edge of the king pin plate.

C: Measure from the rear edge to the leading edge of the king pin plate

DIFFERENCES IN FIT TERMINOLOGY, CUSTOM VS. MULTI VS. UNIVERSAL

CUSTOM FIT

Designed to work with popular king pin box models - simplifying and significantly reducing installation time. To identify the correct Capture Plate for a specific king pin box on the trailer, use the search guide.

MULTI FIT

Designed to offer even more flexibility and will fit a much wider selection of king pin boxes by using a design that accommodates all ''C'' measurements. Simply confirm your trailer's "A" and "B" measurements to make certain the Multi Fit is the Capture Plate for you.

UNIVERSAL FIT

Can be used for most trailers. Simple but can be time consuming to install. In cases where the fore-to-aft dimension of the king pin box is very short, extension plates and knee braces are added to support the Capture Plate.

PULLRITE SUPERGLIDE CAPTURE PLATE RESOURCES